Query Regarding Assign Planning Plant to Plant

[Former Member]

Hello,

I was practicing PM configuration and stuck with assigning planning plant to the plant. Through spro and assign path, when I go to the assigning page get this message (picture). But there is no such planning plat that message asking for. My created planning plant is not the one message showing. 

Would you please describe the reason for such message. For your information, I am new at PM Module.

Regards,

Ashkul Milton

[MTerence · Accepted solution]

Hi Ashikul,

In which system you are doing this config, test system used by many others who can do configure?

If the plant 1610 is not related to your configured planning plant, then it can be like some one created this and deleted the plant or planning plant and forget to remove this config.

In standard SAP will not allow you to save unless you correct the redudant data.

First check whether this plant 1610 needs to be there are not, if it is not required, remove the planning plant assignment and save. System should work.

Regards

Terence

[Former Member · Accepted solution]

Hello Terence,

Thanks for your reply. Yes it is test system, used by many others.

It will be helpful, if you tell me the way of deleting this 1610 plant wholly. Seems like this plant is not needed.

Best Regards,

Ashikul Milton

[psr2412 · Accepted solution]

Hi Ashikul,

Refer below screen shot to delete plant & planning plant through logistic-General in SPRO.

Step-1

Step-2

step-3

step-4

step-5

Plz. try & revert back.

Regards,

PS R

[MTerence · Accepted solution]

Hi Ashikul,

To resolve your issue, just remove the planning plant assignment.

SPRO - Enterprise Structure - Definition - Plant Maintenance - Maintain maintenance planning plant

If this plant is not used in any PM area, system will allow you to delete, if it was used, then you will be able to delete it.

For deleting the plant, you need to consultant with MM Consultant, since this can be used in any other area.

As you said, its a test system, try to overcome this error with out deleting it. Safest method.

Regards

Terence

[Former Member · Accepted solution]

Hello,

Thanks for your reply, but the path you suggested is not showing any plant named 1610 that I want to delete. But, still, while trying to assign the planning plant to plant it shows the message like the picture.

Is there any other way? Thanks in advance...

Best Regards,

Ashikul Milton

[MTerence · Accepted solution]

Hi,

Can you share the screenshot of the these two config

1. SPRO - Enterprise Structure - Definition - Plant Maintenance - Maintain maintenance planning plant

2. SPRO - Enterprise Structure - Assignment - Plant Maintenance - Assign maintenance planning plant to Maintenance plant.

Regards

Terence

[rakesh_kushwaha]

Hi,

Plant might be deleted either from Logistic-General or from definition configuration of Planning Plant. Probably it may be stucked in assignment.

You can check existence of Plant In table T001W  through SE16  T Code and can be deleted by selecting Plant 1610 line item, if it is not required.

Go to Table Entry utility Menu>> Delete

If this is deleted from Logistic -General then delete Planning Plant line item from Definition Configuration.

Regards,

Rakesh

[Former Member]

Hello Rakesh,

I have tried through SE16 and give the plant name as 1610, but it is showing that "no table entries found for specified key." Is there any other way? Thanks for replying..

Best Regards,

Ashikul Milton

[psr2412]

Hi Ashikul,

Plz. go through following useful link on SAP PM configuration. Your issue will get resolved.

https://azapoetrikoe.files.wordpress.com/2007/12/pm-overviewdoc-config.pdf

Regards,

PS R