cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with QM inspection in QE51N

m_sigl
Explorer
0 Kudos
92

Dear all,

we are using a standard inspection and want to check all parts and after that we decide how many of them are OK and how many are not OK. Since one week the inspection scope is as follows:

Inspect     1*1,00     PC

What has changed? The inspection plan and also charactarisitcs of the inspection plan are the same. Where can I change this setting.

Thank you very much for your help.

Best regards,

Markus

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

actually its very difficult to understand what exactly you are looking at .Since one week the inspection scope means what?

Do you mean inspection scope has changed ?

This Inspection scope is actually derived from the kind of sampling procedure that you are using against MICs'.So chaeck the sampling procedure agsint each MCI in the task list @ char level.

Answers (0)