cancel
Showing results for 
Search instead for 
Did you mean: 

PE51-ATTRIBUTES

Former Member
0 Kudos

Hi All

how to increase an existing form length in current size. it is in non-editble mode. current size of form line is 43. i want to increase it upto 65

regards

Accepted Solutions (0)

Answers (4)

Answers (4)

0 Kudos

I had same issue with trying to increase the max size. After 4 years from original post.....

So PE51 (change) -> attributes, i see Maximum size and Current size

say current size line = 79 i want to increase to 81

Only editable is Maximum size-Line...

i change it to 81..save and get out....come back in...

i still see Current size-line show 79.

To resolve this.... (not really resolve...if u think about it)

Click on Next Screen botton which takes you to Change Background.

Initially, at the bottom of screen will show "Line 1 of 79"

but u can insert blank line and max you can insert upto 81 (remember i increase 3 extra lines)

You can click on New Line button

Once u insert max up to max...81...the New Line button will disappear...

Save and go back to Attribute screen....you see 81 now!!

So....Current Size IS current size =)...

hope this helps

Message was edited by: Will Hong I finally understand what fat bear is talking about and it make sense 😃

Former Member
0 Kudos

its not yet answered

Former Member
0 Kudos

Hi All

how to increase an existing form length in current size. it is in non-editble mode. current size of form line is 36. i want to increase it upto 40.

regards

former_member47879
Active Contributor
0 Kudos

You need to do it in the attribute section

PE51 > select your country grouping > and the form > attributes > change

Change the lines 65 to 132

thanks

Former Member
0 Kudos

is it possible to change in current size

former_member47879
Active Contributor
0 Kudos

132 is maximum

Former Member
0 Kudos

add more lines in background

further info: the current line and column in attribute are for display purpose

vikram_n
Contributor
0 Kudos

Hi

Please use the T.code Pe51 Select Attribute and change the max line

With regards

Vikram