MIC

[former_member512784]

A drawing has 3 dimensions, all are length lets say Length A, Length B and Length C

Pease advice should it be required to create separate MIC for all length or enough, if one MIC is created and renamed its description in Inspection plan.

Assuming that all are having same requirement in control indicators.

[Former Member]

Its depends upon the type of Model you are using.

If Incomplete copy model then you can dynamically control the dimensions of mic in task list .

if you are using complete copy model then better to create 3 distinct MIC's.

[Former Member]

Dear

yes u can create one MIC and assign it 3 times to a materials , even u can change the indicators and limits

Edited by: nasir ilyas on Feb 13, 2012 12:29 PM

[Former Member]

Hi

No need create different mics single mic you can control these parameters

hope it will helpul to you

Regards.

M B Raju

[former_member512784]

If I maintain single MIC for all lenth A,B,C, and if suppose want to see the trend of only Length B, Is it possible to see with the MIC that it created commonly.