cancel
Showing results for 
Search instead for 
Did you mean: 

Message N°. BM312

former_member556811
Participant
0 Kudos
882

Dear Experts

During the execution of the transaction IP30, I get this error message

I checked with CUNI transaction, the unit of measurement Time is created.

Please someone can have a solution for me.

Thank you

Accepted Solutions (1)

Accepted Solutions (1)

paul_meehan
Advisor
Advisor
0 Kudos

Hi,

This error occurs if the time unit TAG has been removed as a unit of measure. It is required for internal conversions. You will need to create a time unit TAG through transaction CUNI. See note 1641868 for more information.

-Paul

former_member556811
Participant
0 Kudos

please Paul, I can not access the site. if you can send me a note via attachment, tank a lot

paul_meehan
Advisor
Advisor
0 Kudos

Hi,

Run CUNI, Enter 'Time' as dimension and press the 'Units of measurement' option.
Fill values as shown on this screenshot.

Some warning/errors may be issued depending on what other entries exist on your system. The following shows how each can be handled:

-Paul

former_member556811
Participant
0 Kudos

Thank you paul,

Thank you all.

my problem is solved

Answers (2)

Answers (2)

former_member182535
Active Contributor
0 Kudos

Hi Raoul,

                  I think as this error is concern from cost unit (MO) have not maintained in the Unit table.

So, please check and maintain for the same as well as check Define default UOM in SPRO as mentioned post.

Former Member
0 Kudos

What is the UoM "TAG"??

Are you using this UoM in the operations?? Have you tried creating PM Order manually with that UoM??

IMG - Plant Maintenance and Customer Service - Maintenance & Service Processing - Maintenance & Service Orders - General Data - Define default values for units for operation

Check whether "TAG" has been assigned to your PM Order type.

former_member556811
Participant
0 Kudos

tank you Maheswaran KD,

I use the minute in operations.

IMG - Plant Maintenance and Customer Service - Maintenance & Service Processing - Maintenance & Service Orders - General Data - Define default values for units for operation, the UoM minute is defined.


Transaction IP10 runs without difficulty.


But In IP30 transaction, I use the day as a unit of Interval for Call Objects and get the error message.