cancel
Showing results for 
Search instead for 
Did you mean: 

MCI5 Switch drilldown shows only Key twice

sunil_mundhe3
Contributor
0 Kudos

MCI5 Switch drilldown shows only Key twice

In MCI5 when Switch Drill down executed and Key and

Description option

selected, shows only Key Twice.

Ideally it should show Key and Description. But it shows only

Key twice.

Kindly suggest at the earliest.

Steps for Reconstruction

Step1: Execute MCI5

Step2: Switch Drill down by equipment.

Step3: Select Key and Description.

Step4: Switch Drilldown on Code group: damage

Error occurs here.

Accepted Solutions (0)

Answers (2)

Answers (2)

madhurnigam30
Explorer
0 Kudos

Hi Guys

Any update on any new SAP note for ECC 6.0

Former Member
0 Kudos

We are in to ECC 6, Stil looking for a solution for the same problem..

former_member478182
Active Participant
0 Kudos

Hi there,

the functionality does not change in higher release, the explaination in old note 145601 is still valid for all the release.

Regards,

Jane

Former Member
0 Kudos

Sunil,

The moment you switch drill down the characteristic text associated to the key isn't obtained in certain cases and hence the key is displayed twice. There was a OLD OSS note describing this scenario, i am not sure if this is scenario is still valid.Check OSS for resolution.

Regards

Narasimhan

sunil_mundhe3
Contributor
0 Kudos

I Have found the exit= RMCSTEXT for text retrieve for key description and i did coding as follows for Code group but not able write a code for (CODE).

for code group it is working fine can you plz help me for code

Code:-

CHECK NOT i_fieldvalue IS INITIAL.

CASE i_domname.

WHEN 'QCODEGRP'.

SELECT SINGLE kurztext

FROM qpgt

INTO e_text_short

WHERE sprache = sy-langu

AND codegruppe = i_fieldvalue.

WHEN 'QCODE'.

WHEN OTHERS.

ENDCASE.

Former Member
0 Kudos

You should be able to get the text from QPCT,

Regards

Narasimhan

sunil_mundhe3
Contributor
0 Kudos

yes, i knew text can be retreived from QPCT but when i select the Switch drill down by damage (code) how do system come to know that the particular code belongs to certain code group and the text is this.

Example:

You could find the following situation

Catalog :Cause 1 > Assigned notification type M1

0001 PC fails

_ A Monitor is broken

_ B CPU doesn't work

Catalog: Cause 2 > Assigned notification type M2

0001 CAR fails

_ A Motor fail

_ B Paint

the text for cause A. It could be "Motor fail" or "Monitor is

broken"

Former Member
0 Kudos

Exactly, That is the problem why the code is displayed twice and not the description whenever you move away from the standard drill down, or whenever its unable to determine the superior characteristics. That's the drawback of the design.As indicated above check the OSS for any newer notes on this.

Regards

Narasimhan