cancel
Showing results for 
Search instead for 
Did you mean: 

mb1b

Former Member
0 Kudos

can anyone explain step by step how to do two step procedure transfer posting storage location to storage location using movement type 315.

Locked. Failed to search properly.

Edited by: Csaba Szommer on Apr 21, 2011 8:17 AM

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

1. T Code: MB1b

2.Enter the following

Movement Type

Plant

Storage Location

3.Enter the mterial

Enter the qty

Enter the batch number

Enter and save it

Thanks

Senthil

Former Member
0 Kudos

Hi

Check out the links - You get the full details of Transferring material from one SLoc to SLoc

http://help.sap.com/saphelp_45b/helpdata/en/c6/f843414afa11d182b90000e829fbfe/content.htm

http://www.sapfunctional.com/MM/StockTransfer/Configure.htm

http://architectsap.com/blog/sap/how-to-setup-stock-transport-order-between-two-storage-locations/

Its already explained the steps to transfer stock from one SLoc to SLoc in MB1B .

Regards

Anand

amitbakshi3
Active Participant
0 Kudos

Hi,

Unless you have a specific reason of using Mvt type 315, I would say, for St Loc to St Loc Transfer you can easily use Mvt type 303 (for removal) and 305(for placement) which is SAP standard.

Alternatively, you would need to create another movement type by copying from Mvt 303 & 305. Use T-code OMJJ for the creation of new Mvt Type.

Hope this helps,

best regards

Amit Bakshi

amitbakshi3
Active Participant
0 Kudos

Hi,

Please ignore my earlier post. I did not read your question carefully. My Apologies...

For St Loc to St Loc Transfer you can easily use Mvt type 313 (for removal) and 315(for placement) which is SAP standard.

Alternatively, you would need to create another movement type by copying from Mvt 313 & 315. Use T-code OMJJ for the creation of new Mvt Type.

Hope this helps,

best regards

Amit Bakshi

Edited by: AMIT BAKSHI on Apr 21, 2011 6:40 AM

Former Member
0 Kudos

Hi,

1. First you have to maintain that particular material in both storage locations against the plant in MMSC T code.

( Inputs: Material code, Plant & outputs : required storage locations ).

2 . Go to MB1B , Mov type : 313, plant, give sending storage location, press enter, then give receiving S.loc, material code, qty, unit of measure, Save.

3. Go to MB1B, Mov type : 315, plant, give Receiving storage location, press enter, material code, qty, unit of measure, Save.

4. Now we can check stock against that particular material in MMBE.

( Stock will deduct in sending S.Loc & will Add in Receiving S.Loc. )

Hope this will solve your issue.

Regards,

Aruna.