cancel
Showing results for 
Search instead for 
Did you mean: 

Is it correct ?

former_member183819
Active Contributor
0 Kudos

Hi

one material has basic unit of measurement is EA and Order Unit as RL (reel)due to business reasons/ or due to migration time no one noticed.

1 EA = 1 RL.

is it correct?

so far POs are created with RL .

What decision might have forced to do 1 EA = 1 RL

any help is appreciated.

Muthu

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

What is reel defined as in CUNI config? Is it defined as no dimension? If so, there should be no harm in defining reel as each. There could always be a possibility to define 1 reel as 1 Ea.

we need to know how it is defined in CUNI and what actually it should have been defined as (length dimension, etc)

regards,

Answers (1)

Answers (1)

Former Member
0 Kudos

yes you can maintain as 1 EA = 1 RL, before that define RL as unit of measure using CUNI

maintain alternative units of mesure at basic data view > additional data > unit of measure tab

former_member182489
Active Contributor
0 Kudos

In the business scenario, if 1 EA= !reel . No issue. If not it is an issue and maintain in material master - addtl data- Atl UOM , maintain conversion factor.

And it will be in effect from then only and not for the previoys posted one.