cancel
Showing results for 
Search instead for 
Did you mean: 

Inspection type/origin 17. Not able to assing inspection plan.

dirk_freyaldenhoven
Active Participant

We have connected a decentralized EWM to our SAP ERP. After goods receipt for purchase order in EWM, an inspection lot type/origin 17 (externally Triggered Inspection) is created in SAP ERP.

If I try to assign an inspection plan with sample drawing procedure to the inspection lot the following errormessage will be raised in QA02.

QA-323: Inspection point field combination for inspection plan &1 or &2 incorrect

I have in header of the inspection plan a sample drawing procedure assigned.

The value for "Insp. Points" is 200 "Inspection point for phys. sample".

Johannnes
Explorer
0 Kudos

Morning Dirk,

today SAP's answer arrives..

Currently physical samples in combination with an EWM system cannot be calculated on ERP side.

Best regards

Johannes

Johannnes
Explorer
0 Kudos

SAP Note 2506239 for this is a modification and should be carefully tested...

Best regards

Johannes

dirk_freyaldenhoven
Active Participant
0 Kudos

Morning Johannes,

thanks for you informations, but I'm not authorized to view SAP note 2506239.

SAP note 2692408 was already implemented, but doesn't solve the problem.

Can you provide note 2506239.

Regards, Dirk


Johannnes
Explorer
0 Kudos

Morning Dirk,

sorry that i hav'nt answered for this long time, but I lose this out of my focus. Is your problem solved?

Best regards

Johannes

View Entire Topic
Johannnes
Explorer
0 Kudos

Hi Dirk,

have you a solution for your problem, I have the same issue ,thanks!

Best regards

Johannes

sourabh_maheshwari2
Active Participant
0 Kudos

Please follow the solution that abhishek has provided above

if you get an error after that, then please post the error here

dirk_freyaldenhoven
Active Participant
0 Kudos

Hi Johannes, I opened an message at SAP. After solution, I will let you know. Best regards, Dirk

Johannnes
Explorer
0 Kudos

Hi Dirk,

that's fine, thank you in advance!

Best regards

Johannes

Johannnes
Explorer
0 Kudos

Hi Dirk,

take a look at this note 2692408 if it solve your problem...

https://launchpad.support.sap.com/#/notes/2692408

You have defined on header level inspection points 200. If you have set up inspection points (physical samples), EWM has to provide the physical samples as well.

best regards

Johannes