inspection points time

[ps0410]

Hello! Tell me please, How to set an interval in days to create a inspection point. I know that in QP02 operations, but where exactly? If possible, please tell me the process of the inspection points. I figured out the creation, but I didn't fully understand the process itself

[memem]

.

[memem · Accepted solution]

Greetings,

you can follow the procedure as described in the following blog:

https://community.sap.com/t5/enterprise-resource-planning-blogs-by-members/in-process-inspection-in-...

Essentially you need to properly define master data (sampling procedure, inspection plan or routing) and then create inspection points manually or automatically if the scenario supports it. 

The following fields are not available in QP* transactions.

Best regards, M.

[ps0410 · Accepted solution]

Hello, and if I use inspection type 04

[memem · Accepted solution]

Greetings,

the functionality is the same but depending on the process your inspection lot will be created at goods receipt if you are not using early inspection lot creation functionality.

Best regards, M.

[ps0410 · Accepted solution]

See the article, it says to use CA02, but in 04 inspection type, we use QP02. If I use CA02 for 04 inspection type, I will need to add characteristics, but why add them if we use QP02. And for 04 inspection type, QP02 is used, I have never seen CA02 used

[memem · Accepted solution]

Greetings,

yes you need to prepare different master data for 04 inspection. The preparation is very similar. There might be a problem since in inspection plan the following fields are not available.

Best regards, M.

[ps0410 · Accepted solution]

In my opinion, just for the 04 inspection type, we use the QP transaction, because in the header we have a different use of 05, not 01. If we use 01, there will be errors

[ps0410 · Accepted solution]

I don't have a window like you have in the screenshot. Is the screenshot taken from the CA02 transaction?

[memem · Accepted solution]

Greetings,

that is correct yes. The screenshot was taken from CA* transaction. The fields are not available in QP* transactions.

Best regards, M.

[ps0410 · Accepted solution]

Can we use time points for type 04 verification in QP02? Tell me, please, have you tried the method described on other inspection type, for example 04?

[memem · Accepted solution]

Greetings,

you can use inspection points in 04 inspection type BUT unfortunately you cannot define the interval of inspection since 04 inspection is primarily intended for inspection at goods receipt. Even if you use 04 with early inspection lot creation you cannot define the interval.

The end result is that you CAN use inspection points in 04 inspection type but you cannot define the interval of inspection. Inception points are always created manually. 

Best regards, M.

[ps0410 · Accepted solution]

thank you very much)