cancel
Showing results for 
Search instead for 
Did you mean: 

Inspection lot not showing in QA32 for inbound delivery (QM view is correct)

0 Kudos
416

Dear All,

I faced the issue where inspection lot was not created in QA32 for incoming delivery.

Transaction VL32n shows C (completed) in GR.

MB51 shows mvt 101.

QM view was prepared correctly and material was added to inspection plan.

QALS table shows nothing for this batch number.

MD04 shows inspection lot containing only 0s.

Do you have any advices what else should I check?

View Entire Topic
MilindNikam
Explorer
0 Kudos

Hi Anna,

Which type of inspection lot is expected - it is 01 or 1701 for EWM inspection?

If it is EWM then please check Inspection rule is defined

Regards,

Milind

0 Kudos

Hi Milind,

Inspection types are 04 and 17 (this material is stored in EWM). All indicators are set. In general we produced this material by ourselves. This time we bought it. However, I don't think this cause a problem here because there is also another material with same settings and it work properly.

I found out that the tolerance was too small and parts get stuck in queue. My Colleague increase the tolerance but we still can't see the inspection lot