cancel
Showing results for 
Search instead for 
Did you mean: 

Inspection lot Error while executing MIGO

Former Member
0 Kudos

Dear SAP Gurus,

I have executed MIGO once for a particular material and vendor, for which i have activated inspection setup in material master. So I have successfully executed MIGO and also lot quantity for required qty in MIGO was listed in stock overview.

Again, when i wanted to do MIGO for same material and vendor, I am get the following error msg: QA228

" No inspection lot can be opened for this material and vendor"

Please help.

Regards,

Prashanth Pai

Accepted Solutions (0)

Answers (7)

Answers (7)

Former Member
0 Kudos

Thanks

Former Member
0 Kudos

Dear Prashanth

Please cancel the GR, now check the following

1. material master qm view, did you add the 01 insp type, check , check the post to inpsection lot chk box is activated or not.

2. check whether movemnent type 101 is activated for Insp lot creation during GR or not eithr inside QM for logistics or IN Txn OMJJ

3. Ensure You already have the quality plans with Task assigned. Your inspection types should have the characteristcis assigend to it

chk out all once ok then you do the GR

regards

Former Member
0 Kudos

HI,

There is a Step up in the QM in the Quality info record in the inspection control tab.

the Source inspection can be 01- GR for the Purchase order.

Source Inspection lot exits then no GR (a check box is present).

that might be the key reason.

or else it might be the release date

or blocking reason or the released quantity.

hope so it helps

Regards

Anjanna

Former Member
0 Kudos

Hi,

Pls check the Control Ins Lot Indicator in QM Views for inspection type 01 ( Under detail information on inspection type) & let us know the same.

Thanks & Regards

Kundan Kumar

Former Member
0 Kudos

Dear Kundan,

Control Ins Lot indicator was unchecked, as suggest by you I have checked. But still facing the same error.

Former Member
0 Kudos

Hi Prashanth,

Actually in material master QM View ( Under inspection set up - Inspection Type 01 ) you have the option of selecting some value like 1, 2, X, Blank for Control Ins Lot.

Please let us know the same.

Thanks & Regards

Kundan Kumar

Former Member
0 Kudos

Check number ranges of inspection lot.

Also check quality info-record. Have u given any block qty in info-record?

Former Member
0 Kudos

Check if you have blocked the material/Vendor there in MIGO??

Former Member
0 Kudos

hi,

whether u r doing the migo for the same po?

then u will get this message because already one inspection lot is existing.

regards

jash

Former Member
0 Kudos

No, I have created new PO and executed the MIGO