cancel
Showing results for 
Search instead for 
Did you mean: 

How to Block Quality Inspection Material from Being Issue.

former_member643572
Participant
0 Kudos

Hi Experts,

Is it possible to Issue material though it is Under Quality Inspection because Im facing this issue,

So please suggest me how to clear it from Ls24 for the same because im trying to clear it using

Lt01.And Also how to block quality stock from being issued.

AS you can see the report LS24 as below :

251 RMFLOOR Q 70 kg

RMWH 0000011182 0

902 4500003750 70- kg

RMWH 0000011182 0

922 TR-ZONE 70 kg

RMWH 0000011182 0

922 TR-ZONE Q 70- kg

RMWH 0000011182 0

Thanks & Regards,

Olet Malla

Accepted Solutions (1)

Accepted Solutions (1)

JL23
Active Contributor
0 Kudos

All movements start in inventory managment, and there you cannot do any issue from a stock in Quality inspection.

Your mess was created because you did not process the posting change notice in LU04 as the stock was transferred from quality to unrestricted use.

Find the posting chang notice in LU04 and process it.

former_member643572
Participant
0 Kudos

Hi ,

I am trying LU04 as it is showing error " STORAGE TYPE 922 DOES NOT ALLOW NEGATIVE

STOCK FIGURES " AND It take me to LT05 and here failing to do it .

The LU04 Has Below Scenario :

Mov Type Material Batch C

309 RA000105 0000011182 Q

309 RA000105 0000011182 S

Please help to understand the above Scenario

Thanks & Regards,

Olet Malla

Former Member
0 Kudos

The stock was moving either from QI to blocked, or blocked to QI. Nevertheless, there were movements in-between causing the discrepancies. If you are unable to convert the PCN to a TO then you may close the PCN and reconcile the inventory manually.

former_member643572
Participant
0 Kudos

Hi kalyan,

Im trying for the same can u show me the path how to Close the PCN and reconcile the inventory manually.

As it has stuck both In LS24 and LU04 as u can see in my above post.

Thanks & Regards,

Olet Malla

JL23
Active Contributor
0 Kudos

when a stock is released from quality inspection either into unrestircted use or into blocked stock, and this happens at a warehouse managed location, then SAP creates a PCN (posting change notice) which can be seen in LU04, along with a positive and negative quant in storage type 922.

When you process the PCN, then SAP clears one 922 quants with the quaity stock, and exhanges the status of the Q-quant to S-quant in your case.

However, for this scenario it is essential that 922 storage type must allow negative guants.

go into customizing of storage type and active tthe box to allow negative quants, then try LU04 again

former_member643572
Participant
0 Kudos

Dear jugren,

Please im new in WM so please provide me the detail path for config and setting

Thank's

With regards,

Olet malla

JL23
Active Contributor
0 Kudos

especially as you are a newbe to WM, you should take the chance and find your place in IMG.

It does really not help you to become a good consultant by just getting the paths or transactions from a forum.

go to IMG > LE > WM > master data > define storage type

Answers (0)