cancel
Showing results for 
Search instead for 
Did you mean: 

Getting Error " No conversion found for M to EA " during PO Release

Former Member
0 Kudos
284

Getting Error " No conversion found for M to EA " during Purchase Order  Release.

The UOM maintained for the material in the material master is EA and no conversion factor is maintained for EA to M. The PO unit and the order unit in the PO is also EA. Even the INfo Record has EA maintained. Even in the Purchase requisition the UOM is EA.

please help.

Accepted Solutions (1)

Accepted Solutions (1)

former_member210560
Active Contributor
0 Kudos

Dear Anamica,

Please check all the chapter ID you have used for these material, the error might caused by used UOM in either your Chapter ID which is different from the UOM of the material AND/OR you have used UOM when
defining the excise rate for the chapter ID which is different from that of the material's.

Please check both through transaction J1ID.

Regards,

ian Wong Loke Foong

Former Member
0 Kudos

Hi,

First you need to activate the variable order unit in material master rescord in purchasing view then maintain the conversion factors in UOM of Addiational Data subscreen...

Answers (2)

Answers (2)

Former Member
0 Kudos

Thank you everyone for your instant replies.

It was very helpful.

Former Member
0 Kudos

maintain conversion ratio in PO under quantity tab for the material.

Regards,

Dakshesh