cancel
Showing results for 
Search instead for 
Did you mean: 

Getting error no CO 672 message in prod order when printing...

Former Member
0 Kudos

Hi Experts,

Need your urgent help for the below issue.

When giving print of the production order getting error message as "Output device for order type XXXX,Plant XXXX,MRP XXX not correctly" maintained"

Output device for order type XXXX, plant XXXX, MRP 0XX not correctly maintained

Message no. CO 672

Diagnosis

For one of the lists to be printed

  • no entry was found in the output device
  • the entry in the output device could not be evaluated (you should contact your system administrator)
  • no printer could be determined because the output device control ran into an empty table entry.

Procedure

Check the output device control

If you want to use the printer from your user default values, check whether the entry has been maintained.

I have maintain the setting in OPK8 transaction also, but can you suggest what I am missing here. Please find the attached word doc.

Thanks in Advance:)

Piyush

Accepted Solutions (0)

Answers (1)

Answers (1)

dejoy
Active Contributor
0 Kudos

Hello Piyush,

Please check table T496P and see output device maintained for this MRP controller or not(share complete T496P content screen).Please check note   11104 - PPPR: General note on printing production orders       

Regards,

Former Member
0 Kudos

Hello Dee joy,

Thanks for reply, please find the screenshot for T496P. Output device is maintained for the required MRP controllers/order type & plant combination. Still problem not solved.

dejoy
Active Contributor
0 Kudos

Please run report PPCO85EI for this user and check.

Regards,