Error in creating Business Partner using FLBPD1

[Former Member]

Dear All,

While creating the Business partner using tcode FLBPD1, I get the following error.

Also I need help to understand how to start Post Processing Office.

No business partner could be created for customer CFM0031

Message no. CVIC_UI018

Diagnosis

No business partner could be created from the customer selected.

System Response

An error occurred when creating a business partner from the customer selected. This error prevents data from being transferred and saved. This could be due to the following:

Fields have been left blank in the customer that are set as required entry fields for the business partner.

Settings for assigning Customizing values for the customer to the business partner are incorrect.

Procedure

Start the Post Processing Office and check the error message. Make the necessary corrections.

Regards

Arpita

[Former Member]

Hello Arpita,

I faced exactly the same issue and we had to check the entire customer/vendor master data synchronization configurations. We found that many of them were missing when we upgraded to ECC 6.0.

I would suggest you go through the following SAP notes and check whether all configs are in place or not. Then try again.

Note 954816, 956054 and then also 1077616.

Hope the first two notes will be able to help you cope with the issue.

Regards,

Suvarghya

[Former Member]

Note 1077616 helped me out!!

Thank you!!