cancel
Showing results for 
Search instead for 
Did you mean: 

ERP 2005 installation on MSSC platform

Former Member
0 Kudos

Hi,

I am installing ERP 2005 on MS Cluster platform. I have done through the all phases that mentioned in the installation guide successfully up to the phase that Central Instance Installation. When I started to run sapinst it went on very well till phase RFC Check then sapinst got error message saying that ' Make sure that the system is started, that the user DDIC exists and that the password of user DDIC is correct'. When I checked the system status and saw that the system is started and SAP LOGON windows is coming. But I can not login to the system because both of the user SAP* and DDIC is refused by the system. Despite I entered the SAP* and DDIC password at the beginning of the sapinst where I am asked to input system parameters before starting the installation. So I think I am lost with SAP* and DDIC password. I would appreciate if any of you could help on the subject.

Regards,

Ali Taner

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

hi Ali, Welcome to SDN,

Did you try with the default SAP* and DDIC passwords

06071992, 199920706, i am not very sure, since i have move to develpments side now, anyhow post this thread in WAS forum, i am sure you will get the solution.

Regards:-

Santosh

Former Member
0 Kudos

Hi Santosh,

Thanks for the help. It has been usefull to solve the problem.

Regards,

Ali Taner

Answers (0)