cancel
Showing results for 
Search instead for 
Did you mean: 

EAM: EQUIPMENT DISPLAY LISTS

Former Member
0 Kudos

Dear SAP Experts,

While maintaining the equipment masters in the system.

When I maintain the entries through address: IE01 - Create (General)

The Equipment is created and saved the Number range comes: 10000006 equipment created.

But while creating through lists editing :IE10 - Create

We can create the same with names and no numbers comes.

Now When I go to IE03 - Display

The equipments created in the Lists Editing is not shown in the IE03

Please throw some light on this ?

regards,

A S

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Dear,

After creating the equipments through IE10.go to IH01 and with superior functional location u check the equipments .It will show.

Regards,

pardhreddy.c

Answers (3)

Answers (3)

Former Member
0 Kudos

Dear ,

I also checked , but the sysytem is showing all the equipments created through ie10.

Check it once again.

Regards,

Pardh reddy.c

Edited by: pardhasaradhi reddy on Nov 26, 2008 1:44 PM

peter_atkin
Active Contributor
0 Kudos

AS,

Please confirm: There are no equipment created when you use transaction IE10???

PeteA

Former Member
0 Kudos

Dear Pete Atkin,

The Equipments are displayed in the System in IE10,

Is it that in IE03 Display the equipments by address selection service, Equipment by serial number lists , equipments by functional locations are different.

The Master Data of all the equipments are the same.

Why can't it be displayed in the IE03 when I press F4 key........

Thanks ,

A S

Former Member
0 Kudos

Hi AS,

When u create equipment thr IE10 u can go for either external numbering or internal numbering.

In IE10 ur inputs are mainly equipment category and plant.If u dont give reference equipment the new equipment(here its 10000006) will just have infos like planning plant,maint plant and equipment category.It doesnt have any other infos stored in it.(check the particular equip thr IE02)

So when u try to display the equipment thr address selection service, Equipment by serial number lists , equipments by functional locations,system wont display ur newly created equip since those datas are not maintained for that particular equipment.

So just search the equipment thr IE03 by giving the maint plant in Location data tab or planning plant in maintenance data tab and also maintain the period correctly in the euipment selection tab.

U will get the entire list of equipments of that plant.

Hope this will help

Regards,

Ebin

former_member187991
Active Contributor
0 Kudos

hi

ie10 is used to create no of equipments at the same time .if you have save the ie10 then system will create the no of equipments you have specified .kindly check it will definitely reflect the created one

regards

thyagarajan