Doc type 0F

[chirui33]

Hi,

I am getting below error while performing "Consistency Check of Settings for FI Integration". I went to doc types and find there is no Doc type 0F available in the system for me. Any one faced similar issue?

No number range found for document type 0F in version D10 of dimension Y1

Message no. G3101

Diagnosis

In dimension Y1, no number range is maintained for document type 0F used in version D10, for the realtime update. Updating documents is not possible without a number range allocation.

System Response

Processing is cancelled.

Procedure

Maintain a number range for the document type 0F in version D10, in the Customizing of consolidation in dimension Y1.

Thanks,

Naga.

[former_member749672]

Hello Naga,

Have you managed to solve the problem? The same thing happens to me, I created the document type 0F from the update view V_TF500 in SM30, now I have the following message:

No number range found for document type 0F in version G10 of dimension Y1

Message no. G3101

Diagnosis

In dimension Y1, no number range is maintained for document type 0F used in version G10, for the realtime update. Updating documents is not possible without a number range allocation.

System Response

Processing is cancelled.

Procedure

Maintain a number range for the document type 0F in version G10, in the Customizing of consolidation in dimension Y1.

---------

I have tried to assign the ranges, however it has not been possible since the document type is not shown in any of the transactions, only in the updated table.

If anyone has been able to solve it, I would appreciate if you share the solution.