cancel
Showing results for 
Search instead for 
Did you mean: 

Do not cost indicator in Material Master - Impact in CO-PA

harnish_shah
Participant
0 Kudos
2,088

Hi,

I wanted to freeze the SFG cost while valuating FG & hence I activated "do not Cost" in SFG material master. Post that when I run cost estimate for FG & try to view the cost component break-up, system does not bifurcate material cost into Raw Material, Packing material etc. but shows under cost component group "SFG". As a result, even CO-PA cost component breakup shown total material cost as SFG. The same is not the case if SFG is not ticked as "Do not Cost" indicator. Meaning: CO-PA cost component breakup shows "Raw Material", "Packing Material" etc.

Can anybody throw some light on this?

View Entire Topic
malay_vakil
Active Participant

Hi Harnish,

To meet your requirement "Do Not Cost" is not right solution. You have to use "Transfer Control" so SFG materials will not valuate when you try to release standard cost for FG

Regards,
Malay

harnish_shah
Participant
0 Kudos

Thanks Malay. It worked.