cancel
Showing results for 
Search instead for 
Did you mean: 

desactivate message MM129 in additionnal data

Former Member
0 Kudos
821

hi

how can i desactivate the information message MM129 in additionnal data in material master.

for exemple i have PC in basic unit in basic data 1 , in additionnal data i put 2 EDU (another unit) => 1 PC and i have this message that the unit is smallest than the basic unit.

in Spro in logistic general =>message system, this message are not and i can't put another entries.

thanks for your answer

serge

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

hi Serge ,

use following config

logistics general -material master - basic settings- define attributes of system messages

there you will find this message.You can change it to warning or error or no message as per your requirement.

Regards

Mangesh

Reward points if it helps.

Former Member
0 Kudos

hi

thanks for the answers but it doesn't work because like i wrote in the first message i don't have the message 129 on this custo point.128 yes but not 129.

Former Member
0 Kudos

hi

i have my answer . Not possible in 4.6 C to modify the message in custo because it's in hard in include LMGD1F2F

   IF NOT KZ_SMALL_UNIT IS INITIAL AND BILDFLAG IS INITIAL
       AND LHMG_UPDATEFLG IS INITIAL.
      BILDFLAG = X.
      MESSAGE S129(MM).
*       Die Basismengeneinheit ist nicht die kleinste ME
*       Entwicklungsantrag 251399
*       Diese Warnung erscheint nicht, wenn geänderte ME = LHME, in die-
*       sem Fall erscheint die Warnung: LHMG wurde geaendert (s119 mm).
    ENDIF.

so i will see in OSS

serge