cancel
Showing results for 
Search instead for 
Did you mean: 

Deleting POs massively.

Former Member
0 Kudos

Hi,

is there an interface where deleting massively POs ?

Best regards

Accepted Solutions (1)

Accepted Solutions (1)

JL23
Active Contributor
0 Kudos

you can set deletion indicators with MEMASSPO or LSMW, or CATT or BDC.

But this does not make the POs going away.

This can only be done with archiving.

Former Member
0 Kudos

Hi,

MEMASS may be the right way but after setting the deletion indicator if I want to reverse the change

I do that but the icon with the recycle bin doesn't disappear and I have doing that manually.

So the reverse must be done with MEMASS and after manually. If I do that directly manually without a MEMASS deletion system doesn't allow this and doing only MEMASS deletion doesn't delete the recycle bin.

Best regards

JL23
Active Contributor
0 Kudos

MEMASSPO has to recognize the same limitations as you have when doing it mamually.

MEMASSPO can certainly remove a deletion indicator, if it does not do that for you, then you got probably messages with red lights.

Read them, as well going into the detail and tell us what the message is.

Further tell us what SAP tells you when you try to do it manually.

Former Member
0 Kudos

Hi,

the parameter I use is MASSEKKO-LOEKZ, is correct modify this parameter or is another one?

Best regards

Former Member
0 Kudos

Fields are:

MASSEKKO-LOEKZ;

MASSEKPO-LOEKZ.

Only deleting both system delete the recycle bin.

Best regards

Former Member
0 Kudos

if I don't delete the value for both fields (MASSEKKO-LOEKZ, MASSEKPO-LOEKZ)

system will always show the recycle bin!!!

Former Member
0 Kudos

that is the solution to my problem deleting the values for MASSEKKO-LOEKZ, MASSEKPO-LOEKZ removing the X related to the above fields in MEMASSPO setting

blank in "New Values" instead of X

JL23
Active Contributor
0 Kudos

How did you get a value to EKKO-LOEKZ ??

This field is only used by archiving programms.

Former Member
0 Kudos

Deleting the "X" value in the columns for both fields I indicated

JL23
Active Contributor
0 Kudos

I understood the deleting from, but I asked how you got the value to this field.

Former Member
0 Kudos

Hello,

I was doing MEMASSPO to mass update storage location in the PO. The output says it is updated, but I went go to back to the PO it didn't update. It looks as though commit is not being done. Where do I indicate when running MEMASSPO to commit the transaction?

Thanks,

S

JL23
Active Contributor
0 Kudos

You should have opened an extra thread.

What output tells you that it is updated?

Did you have green traffic lights?

Have you checked for posting failures in SM13 ?

Former Member
0 Kudos

Below is the message I received from the syetem with the GREEN light:

0041057356 : Competitive PO 41057356 changed

I went to MSL1 and that shows changed successfully.

Thanks,

S

JL23
Active Contributor
0 Kudos

see OSS note 357753 - Mass maintenance: new field values not saved

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi,

You can develop LSMW for that or You can do it through MEMASSPO.

Thx

Raju