cancel
Showing results for 
Search instead for 
Did you mean: 

Contract Target Value to PO

Former Member
0 Kudos

Dear All,

I am having a Service PR with value 2,695,929.00 USD, also one contract with Target Value 7000000 SAR, but in the service specification of contract, value is 5.00 SAR.

Now I had created release order with ref to both PR and Contract, and PO had captured 5.00 SAR from contract service specification. But the buyer had changed the currency as well as value in PO to 2,695,929.00 USD which exeeds contract value. System message 06/042 and SE/347 is set to the status "E". Still for the above process system not showing Error "Target value of contract & exceeded by & &".

Please advice.

Regards

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi

Can you check T code OLME & Set meassge { appl 06 and Msg No 155 to "E"(error msg)}for target value in following path:

MM> Purchasing> Environment data>Define attibutes of system message>system message.

regards

Narahari

Former Member
0 Kudos

Dear Biju/ Narahari,

06/155 Contract target value & reached already was in "E".

BijayKumarBarik
Active Contributor
0 Kudos

Hi,

As you are for target value set error message {appl 06 and Msg No 155 to "E"(error msg)} in following path:

SPRO->MM> Purchasing> Environment data>Define attibutes of system message-->system message

Regards,

Biju K