cancel
Showing results for 
Search instead for 
Did you mean: 

Characterist. must be created

former_member567315
Participant
0 Kudos

Hi Gurus,

I have this case. I cant REL the inspection lot, for all inspection types. I've check my settings, Configuration and master data, they were all right, even the dates. My config and master data is set prior assigning inspection types in a material. task list usage are linked, all status for both master data and configuration are in released. Inspection plan are made correctly.

On my couple test it worked fine, however, suddenly, after a day the above problem appeared.

Thank you guys.

Accepted Solutions (1)

Accepted Solutions (1)

former_member567315
Participant

Thanks Craig for the response. I checked all the parameters,setting and master data, all are correct.

The case is resolved. We found out that "task list usage status" settings is change. we just changed the configuration to default.

I'm closing the thread.

former_member42743
Active Contributor
0 Kudos

Great! thanks for updating and closing the thread!

Answers (1)

Answers (1)

former_member42743
Active Contributor
0 Kudos

Check two things. In the inspection plan or routing, see if the control key used on the operation specifies characteristics.

In the material master, for the inspection type setup, see how "check characs" it set.

Conflicts between these two things can result in what you are seeing.

Craig