cancel
Showing results for 
Search instead for 
Did you mean: 

Bom explosion problem !

Former Member
0 Kudos

Dear experts

I am facing a problem on bom explosion in po. In PO there is no co-product is showing while bom explosion butother components are showing.But in Tcode CS12 all components along with co-product is showing .I have checked all settings like co-product material master MRP2 view co-product checkbox is ticked, In BoM also co-product item details co-product is ticked . Finished product  MRP 2 view special procurement  is set 30(subcontracting) . Bom validity is also ok. Help to solve the issue.???

Accepted Solutions (0)

Answers (2)

Answers (2)

Prasoon
Active Contributor
0 Kudos

Hi,

   In addition to Jurgen's points, Could you please maintain the item with quantity as negative as shown below (without any other settings in BOM) and check the scenario again with a new PO with item category L.

Regards,

AKPT

JL23
Active Contributor
0 Kudos

are you certain that you look at the right BoM? Maybe you have more than 1 BoM.

Change the component quantity of another component in CS12 and check if this change is taken into account when you create a new item in the PO, if yes, then you can be certain that you are dealing with the same BoM. Then you should post some screen shots to enable others to check if your setup is correct. (you may hide names, but please keep the numbers visible)