cancel
Showing results for 
Search instead for 
Did you mean: 

Backflushing Error

Former Member
0 Kudos

Good evening,

I am trying to Backflush a Fin product and I am getting the following message in COGIA report: -

The repetitive manufacturing profile is set for the reporting point procedure. However, either no reporting points exist for the material or they are incorrect. Two common reasons for this are:

u2022 The repetitive manufacturing profile has been changed in the current session.

u2022 You have not defined any milestone operations in the routing.

u2022 When creating the product cost collector, no reporting points were created.

I am a bit little bit puzzled on this,

What should I check?

Thanks in advance.

View Entire Topic
Former Member
0 Kudos

Hi,

In material master check the REM profile in MRP4 view. It should be 0001 - Auto cost collector,w/o activity backflush.

In your case Reporting point backflush profile is assigned. If you want to do RP backflush, in the routing assign Milestone confirmation.

And for RP backflush, in MFBF screen make tick mark in RP backflush. So for each opn wise you can confirm.

Regards,

Dharma