Showing results for 
Search instead for 
Did you mean: 

Add View to overview page error

Former Member
0 Kudos


I have created a view based on a "Z" Bol entity as follows:

- I've enhanced the BT121h_SLSC component

- I've created the View with context node based on my BOL entity "Objectives"

- i've added my view to my view set " contract_OP"

- i did the needed configurations ...

When i try to execute the page I get this message: ( translated from french)

No controller "Objectives" exists in the BSP application BT121H_SLSC/ContractOP.

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hello there,

The error message reported by you appears when the Context node class is not generated properly.

For the same check the following:

1. Check the CL_CRM_XXXXXXXXXX_CTXT class with the correct super class CL_BSP_WD_CONTEXT_NODE

2. If the Context Node/View is a table view then it should have the super class as CL_BSP_WD_CONTEXT_NODE_TV.

Also I can get from your question is that you have enhanced the component.

In such cases; please refer to the given link.


Please reply if this helps.

Best Regards,