Application Development Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Showing results for 
Search instead for 
Did you mean: 

Outbound idoc

Former Member
0 Kudos
68

I have created a new message type & linked it.

Now the idoc is generated successfully in the source system but not distributed in the target system.

in target system too i specified the partner profile.

May i know wats the error.

Thanks in advance.

7 REPLIES 7

Former Member
0 Kudos
42

Two possible reasons,

1. The distribution model is not defined or cantains errors.

2. Message type does not exist in the target.

Check these out

0 Kudos
42

cdm is distributed in the target system & in the target system also i have this message type.

Former Member
0 Kudos
42

hello,

check the CDMA part and it should be disitributed.

Former Member
0 Kudos
42

could u specify more briefly?

Former Member
0 Kudos
42

Whats the status of the idoc in the source and the target system ?

if source(sending logical system) idoc is 53 and target status(Receiving LS) of idoc <> 53

check the error status ..

regards,

Vijay

former_member404244
Active Contributor
0 Kudos
42

hi,

did u created model view in BD64 and distributed it.....chek the same..

regards,

nagaraj

Former Member
0 Kudos
42

HI,

Check your Source & target system

It should have same settings in both systems

Check for all the following :

message type

Idoc type

rfc connection

partner profile

SAP version

Thanks

Sunil