iam doing bdc with call trnsaction.
in call transaction display error message for a mrp value in transaction and continue with another value.
in bdc for transaction iam passing multiple mrp controllers .
for each nad every value it should perform call transaction
display error message and continue with another value .
iam getting system error message and stoping not continuing with another value.
CALL TRANSACTION tcod ... MODE mode
The specified processing mode can accept the following values:
'A' Display screen
'E' Display screen only if an error occurs
'N' No display
If the addition MODE is not specified, the processing mode is set to 'A' .
The MODE Parameter
You can use the MODE parameter to specify whether data transfer processing should be displayed as it happens. You can choose between three modes:
A Display all. All screens and the data that goes in them appear when you run your program.
N No display. All screens are processed invisibly, regardless of whether there are errors or not. Control returns to your program as soon as transaction processing is finished.
E Display errors only. The transaction goes into display mode as soon as an error in one of the screens is detected. You can then correct the error.