workflow issue after transport to QA system

[former_member196064]

Greetings,

After transport to QA my workflow does not execute the job I've assigned to my step.

I have a program assigned as a background job in a step that gets triggered by a typical workflow event.

I believe this is the first workflow for their system... and it's definately my first as well.

I can see the workflow executing using the trace.... but my job never runs.

I'm beginning to suspect I need to refresh the workflow buffer... but perhaps it's an authorization issue

Please advise...

Doug -

[Former Member · Accepted solution]

Doug:

First refresh the memory of the workflow to take the new changes ok, transaction SWU_OBUF.

Just to be sure, check the transaction SWU3 and check if everything is OK.

The posible authorization problem is for the User WF-BATCH, so check the authorizations for this user.

Best Regards,

Jessica

[former_member196064]

Yup... it's all good

[former_member196064]

Never mind... I'm an idiot.

SWUD, Workflow diagnose,kept telling me "the job has no steps"... stared at it for 2 hours till it dawned on me I needed to put the variant it was trying to use... into the program.

Also did SWU3_OBUF... it did look kinda messy in there... but I'm not sure it was necessary

Doug -

[Former Member]

Doug:

So, everything is OK now?

Transaction SWU_OBUF is to refresh the changes of the transport.

Best Regards,

Jessica