S4H to CPI. Need help

[Pravin28]

Hi friends. 

I'm following this blog (https://community.sap.com/t5/technology-blogs-by-members/sap-s4h-idoc-to-sap-cpi-inbound-idoc-interf...) and I'm getting stuck at step 6 of this blog. I'll include a picture to see if someone can help me figure out what am I doing wrong. 

When I try to add message type in the partner profile, the receiver port is not showing the CPI port. See screenshot attached. I have created port similar to how this blog shows in step 5. I'm assuming the port created in step 5 is what should be displayed in the receiver port in WE20, correct?

[Ryan-Crosby]

What does your WE21 information look like?

[Pravin28]

Hi Ryan, 

I have attached the screenshot.

[Ryan-Crosby · Accepted solution]

You should be able to copy/paste the port ID where you have the description 'CPI PORT' directly into your WE20 configuration, and save your entry (Not sure why your search help seems to be restricting the output list).  If you run into a problem saving the entry you can report back here.

Regards,

Ryan Crosby

[Pravin28 · Accepted solution]

This is crazy. Copy/paste worked. Thank you very much. Would you be able to tell me why the search drop down is not showing all options? Is this a config change somehwere?

[Ryan-Crosby · Accepted solution]

@Pravin28it looks like the search help is defaulted to display ports with type = '1' (tRFC), so I'm assuming you did the same as I, and setup a port with type = '7' (XML HTTP).  Note however, that you can adjust which search help is used by clicking the filter option.

[Pravin28]

ignore this, i entered this by mistake.