RSA3

[Former Member]

Hi,

Could someone tell me what data does RSA3 show ? Is it all the data from the very beginning, or only the set up data or the delta data ?

When I check via RSA3, I get data upto a certain date say 13.11.06 only. But the cube has upto date data. How is this explained ?

Sheeja

[Former Member]

Hi Sheeja

Just go to the corresponding source system and check the avalability of the data then go to RSA3 and compare with that am not sure.Let me know

[Former Member]

Hi Sheeja,

With RSA3 you can check the BW extractors in the sourcesystem. You can use it to see how data is structured in the extractor. If for instance you added a field to your extractor, you can check if it works before replicating and connecting to the target system.

What you see is depending on the kind of extractor. Basically it functions as a full load. RSA3 gives you the content of the set-up table. If you create an initialisation in the sourcesystem for logistic exctractors, then only the data in this setup table is displayed using RSA3. Delta records generated after the initialisation are not visible. This is the reason why RSA3 gives records until 13.11.06 (set-up table) and the cube is up to date with all delta records.

Hope this helps,

Regards,

Cerillo

[Former Member]

Basically u can check how many records were extracted from the source system.

regards --- Kumar Sarvepalli

[Former Member]

HI Sheeja,

RSA3 gets the data from the source system base tables.It may get all the data from the source system or if you need you can restrict using the selections like date or some custID and so on.

Hope this helps you.

Regards

Sandeep

[former_member185071]

Hi Sheeja

RSA3 holds only the data which is avilable in RSA7 .

Ofcourse if u have any selction fields then u can restrict according to them by

using DATES in RSA3itself.

Hope itz clear a little atleast..!

Thanks & Regards

R M K

***Assigning pointz is the only way of saying thanx in SDN ***

**Learning the thingz is never end process if u stop it it will Be a devil if u continue it will be a devine***

> Hi,

>

> Could someone tell me what data does RSA3 show ? Is

> it all the data from the very beginning, or only the

> set up data or the delta data ?

>

> When I check via RSA3, I get data upto a certain date

> say 13.11.06 only. But the cube has upto date data.

> How is this explained ?

>

> Sheeja

[former_member197610]

HI,

RSA3 is the Extract Checker.

If you have the calday/calmonth field select the date from which you want to see and extract it.Will display the data based upon your selection.It will display the setup table data and delta data also

Hope this helps