cancel
Showing results for 
Search instead for 
Did you mean: 

Process chain hangs and Next process is not triggering

former_member223213
Participant
0 Kudos
414

Dear all,

I struck with an issue where process chain is getting hanged  and next process is not triggering .

what i observed is DTP is failed to generate Target Event.

What went wrong !!!!!!!!!!!

Accepted Solutions (1)

Accepted Solutions (1)

former_member223213
Participant
0 Kudos

hi Every one ,

Issue is rectified

with the help of basis team.

sap note is implemented.

SAP Note Nr. 830576

Parameter recommendations for Oracle 10g

Thanks & Regards,

Manoj.

Answers (3)

Answers (3)

KodandaPani_KV
Active Contributor
0 Kudos

Hi,

go the DSO manage screen -> check the have any logs ->

right click on the cube -> mangae -> click on the DTP ->  check the any erros.

please share the screen shot better understanding.

Thanks,

Phani.

Former Member
0 Kudos

Hi,

Check the SAP Note 1998206 if the job is completed and the process log table not updated.

Thanks,

Shakthi raj Natarajan

former_member184884
Active Participant
0 Kudos

Hi Manoj,

This issue occurs mainly due to lack of background resources in the system, did you checked number of free process in SM50.

Thanks & Regards,

Harish

former_member223213
Participant
0 Kudos

hi Harish,

back ground resources are 5/5 are in free.

shall i increase the background resource !!!!!!! and tell you know .

Thanks your support .

RamanKorrapati
Active Contributor
0 Kudos

if your dtp loading was done then you can trigger next steps by manual.

After the completion, you can remove your chain from schedule and activate it.

later schedule it. observer your chain on next run.

former_member223213
Participant
0 Kudos

hi Raman,

Yes we can , i have done it manually .

but one process chain hang at dtp of cube then i create index,

it is not set to green and i donot know that indexes are create or not.

Thanks & Regards

manoj.

RamanKorrapati
Active Contributor
0 Kudos

leave about hang.

Go to your target and see the latest loaded request was completed or not.

if its completed then fine.

you may created indexes by manual?

if yes then while creating itself you may see the status.

still have doubts then drop index and again create it at cube-->manage-->performance tab.