Problem In IDX5

[Former Member]

Hi Experts,

There is an error Message in IDX5 when i double click on IDOC Number.

File to IDOC scenario, If we double click on IDOC number it will be connecting to ECC system, but it is showing the error message on the status bar

"Error for the remote call of method RSEIDOC2_CALL_VIA_RFC_DOCNUM in system ZM1CLNT100 message control FrameWork Fatal error - GUI cannot be rea"

Can any body help on this issue

Regards

Sankar

[Former Member]

Hello Sankar,

If you are using AAE (Advanced Adapter Engine), then you will not find the SXMB_MONI part on double clicking the first list display of t-code IDX5, as the IE is completely bypassed. In my opinion, this could be a possible reason why you are getting this error.

Kind Regards,

Souvik

[ranjit_deshmukh]

The RFC connection(type 3) defined for this kind of communication might be using User of type System rather than Service - try changing the user and test again.

[Former Member]

Hi there,

Were you able to resolve this issue? if yes, could you please tell us how you resolved

Thanks in advance

Kumar

[ranjit_deshmukh]

The RFC connection(type 3) defined for this kind of communication might be using User of type System rather than Service - try changing the user and test again.

[prasanthi_chavala]

Hi,

Can check what error it is showing in sxi_monitor for that message?? Have you defined rfc destination of type R3 in your XI system to your target (SAP R/3) system?? Test if the RFC destination is working fine from your XI to R/3 system.

Thanks!!

[Former Member]

Can you check whether user you have used to connect to SAP have sufficient privileges ,also check that the RFC Destination created through IDX1 is fine.

HTH

Rajesh

[Former Member]

Hello,

Refer this note,

Note 327861 - Allowing RFC destinations of type <> R/3 for ALE

Regards,

Sreenivas