cancel
Showing results for 
Search instead for 
Did you mean: 

Options to Stop the process dynamically at Standardization in MDC

0 Kudos
693

Hi Experts,

We have a condition to stop the process dynamically during the Standardization step in our MDC process based on the Address validation results. We have used our custom class and when we tried to raise an exception CX_MDC_PROCESS_STATUS to stop the process the results of the records are not showing up and also the error messages associated with the records not showing up.

Note: Even if we add error message to the log, process is not getting stopped only with an exception it is getting stopped at the step.

Kindly suggest some option to stop the process without affecting the functionalities.

Note: When we set the Checkpoint in MDCIMG for the step it is stopping and messages are displayed properly, Kindly suggest is there any option to set the checkpoint dynamically via any BAdi?

Show results is not showing any records & Chart display is also blank since we raised exception CX_MDC_PROCESS_STATUS

Show results does not show any of the error records

Thanks,

Nalla B.

Accepted Solutions (1)

Accepted Solutions (1)

0 Kudos

Hi,

Solution obtained based on SAP suggestion via OSS incident.

Process can be stopped without checkpoint configured only if it is of Step type Validation (VAL). The Validation status of the step nuember needs to be set as error 'E' in the table BUT000_PRC in field VALIDATION_STATUS.

Thanks,

Nalla B.

Answers (0)