old entries in FDT_ADMN_0000

[ekp_shendi]

Dear Experts,

I am having a strange behaviour of some previously created BRF+ Rules, e.g. CHECK_BP_ROLE for the usage in MDG Change Requests. Our scenario is a Clean Client and a Test Client on the same box, Transport Requests are managed thorugh SCC1.

On the Clean Client, the rule is deleted and cannot be found even in FDT_WORKBENCH, however on the Test Client (same box as metnioned), the rules are avaialable and only marked for deletion.

This leads to problems when excuting the rules during SAP MDG CR processing, resulting in the error message below on the Test Client.

Table FDT_ADMN_0000 is empty for the mentioned IDs in Clean Client, but there are entries on the Test Client.

Any suggestions? I have read similar posts, where the suggested solution was to delete the rules on the Test Client, which is not recommended as I would assume, and in our case not even feasible.

I ran FDT_DELETE on the Clean Client, but cannot run it on the Test Client.

Any hint is well appreciated.

Best Regards

Acram