NO_RECEIVER_CASE_BE

[Former Member]

Hi Everyone:

I am getting this error:

<i> <SAP:Code area="RCVR_DETERMINATION">NO_RECEIVER_CASE_BE</SAP:Code>

<SAP:Stack>No receiver could be determined</SAP:Stack></i>

When reprocessing the interface from the component monitoring(RWB), the problem is that when I send the message, the party is not sent, then there is no Receiver Determination found, I do not know why the party is not in the SXMB_MONI in the inbound message,

Any help?

[Former Member]

Hi:

The scenario is:

http to RFC(to R/3)

The problem is that the <b>party</b> is not showed in the SXMB_MONI when I am sending it through the component monitoring(RWB)

Thx

[moorthy]

Hi,

Did you go thru my points? Are you doing B2B scenarios ???

Just to cross check your scenario /people/shabarish.vijayakumar/blog/2006/09/08/b2b-and-the-hype-about-the-party

Rgds,

Moorthy

[moorthy]

Hi,

Check out these:

1) In SXMB_MONI, do u see correct business service for Sender and Receiver under corresponding column. Both are as expected as you configured in the Integration Directory?

2) Refresh the cache in Directory>EnvironmentRefresh. Also in SXI_CACHE

3) Re-activate the Receiver Determination and receiver agreement .. Hope everything is active

Generally this is because of wrong service used in the receiver side because of inactive or refresh problems..

Rgds,

Moorthy

[Former Member]

Hi Procureto !!

What type of scenario do you have?

Regards,

Matias