Naming of RFC Dest SAP R3->XI->Partner

[Former Member]

Hello,

I want to send an Idoc via XI to different external partners. I know how to setup the RFC dest from R3 to XI and so on...

The question is the following:

How do you name your RFC Destinations in R3 system?

One for each external (the final receiver of the Idoc) or is it recommended to use the XI system as destination for all

How to handle ALEAUDIT messages...seems the better way to name the final partner...

what are the suggestions...

Thanks for your ideas,

bye

jo

[Former Member]

sorry..to many things in parallel...the question is how to name the Logical System in the sending R3 ?

[former_member206604]

Hi,

Even for logical system its the sameway as Bhavesh said for RFC Destination.

Regards,

Prakash

[bhavesh_kantilal]

Hi,

The partner profile name in We20 is best when created with respect to an R3 system. This way, you need not do manipulation of the IDOC control record in your mapping in XI.

The RFC destination created in R3 for XI , should be named as shown in my first reply.

Regards,

Bhavesh

[Former Member]

hi bavesh,

so in sending R3 system you suggest to use the name of the receiving system a.g. a warehouse and not the name of the XI.

thanks

[bhavesh_kantilal]

Hi,

If you are going to be doing an IDOC to IDOC then by naming the partner as your R3 systems then you do not need to manipulate your Idoc's control record in XI.

If you did this wrt to XI, then the IDOC control record will have R3 as sender partner name and XI as receiver partner name... When XI send s the IDOC, the control record will need to be maniuplated with XI as the Sender Partner and R3 as the receiver partner.

I hope this clears the concept. I would recommend naming it( paretner profile ) with respect to the actual partners

The port / RFC destiation can be named with respect to XI and used in the partnerinside the partner profile.

Regards,

Bhavesh

[bhavesh_kantilal]

Hi,

><i>How do you name your RFC Destinations in R3 system?</i>

When you need to send an IDOC from XI to R3 , the RFC destination should be created in XI right? I guess you meant to ask how to name the RFC destination of the R3 in XI.

The normal SAP naming convention is, SYSIDofserv"CLNT"Clientnumber.

example..

XXXCLNT200

XXX-- SYSID of R3

200 -- Client Number.

Is this what you want or have I missed something?

Regards,

Bhavesh