Material Hierarchy not getting completed

[govind_ramesh]

Dear All,

I have activate the Datasources for Material and its hierarchies.

The entire chain is active.

0MATERIAL_ATTR is success

0MATERIAL_TEXT is success

0MATERIAL_LKLS_HIER is having a Yellow Led in RSMO

0MATERIAL_LPRH_HIER is having a Yellow Led in RSMO

The messages shown in RSMO is as seen in the screenshot attached in this thread.

The hierarchies are but shown in RSH1.

Why are these not yet completed in RSMO. Somehow it fails to show the GREEN LED.

Any known issues?

Regards,

GKR

[govind_ramesh · Accepted solution]

Hi All,

I was able to rectify this error.

The issue was that in RSH1 the 2 hierarchies which were pulled in, 026 and PRDHA of infobject 0MATERIAL were not activated completely. When I tried activating each of them individually it stated that 0HIER_HIEID is active byt the object status is inactive.

Hence I refered SAP Notes and found one.

Note no: 1778181

This note suggests to run the report RSDG_IOBJ_ACTIVATE for the object that shows the error.

Hence I ran the report for 0HIER_HIEID.

The hierarchies were then activated without any error.

Now the Job for the Hierarchies LKLS and LPRH completes successfully and is no more in the yellow warning state.

Thanks to all who responded with your ideas and suggestions.

@Suman : I have not changed the LED settings to green as I thought it might be a change to standard. Anyways thanks for that too.

Regards,

GKR

[former_member182470 · Accepted solution]

Thanks for the update. Good to know that your issue is resolved now.

[RamanKorrapati · Accepted solution]

Thank you Ramesh for the update with solution. Please choose your own reply as Correct answer and close the thread. that would be more helpful when others come across the same kind off issue.

Hope you understand.

Thank You

[govind_ramesh · Accepted solution]

Ok,

I shall do so. Thanks.