Material Hierarchy not getting completed

[govind_ramesh]

Dear All,

I have activate the Datasources for Material and its hierarchies.

The entire chain is active.

0MATERIAL_ATTR is success

0MATERIAL_TEXT is success

0MATERIAL_LKLS_HIER is having a Yellow Led in RSMO

0MATERIAL_LPRH_HIER is having a Yellow Led in RSMO

The messages shown in RSMO is as seen in the screenshot attached in this thread.

The hierarchies are but shown in RSH1.

Why are these not yet completed in RSMO. Somehow it fails to show the GREEN LED.

Any known issues?

Regards,

GKR

[former_member182470]

Yellow means some warnings would have occurred. Are you sure the load is completed? Can you wait till the whole process is completed?

Have you made below settings in RSMO?

[govind_ramesh]

Hi Suman,

I did think about making the setting here to Green.

But what if there is some warning which need to be looked into.

If we set this as Green then will we not miss this check in our monitor ?

In both cases in my system it is set to Yellow . Which I believe is the standard setting.

Should I change them to Green ?

Regards

GKR

[former_member182470]

What is the warning message shows? If it is ignorable, you can make it to green.

How many records you getting finally in RSMO? I mean 10000 of 10000 records. If you see same number of records, then your load is completed. You can check all your idocs willbe finished in details tab. In both cases, you can make green as per my suggetsion.