Inquiry about issues stopping replication flow.

[gabriela_jacomino]

Hello Community,

I have been facing an issue with a replication flow that I have been trying to stop for a week, but without success. I would like to know if anyone has experienced something similar and could help me understand the possible causes of this problem.

I have tried several solutions, but the flow remains active. Could you suggest what else I might check or if there are any specific steps I should follow to resolve this issue?

I appreciate any guidance or advice you can offer.

Best regards

[FlavioMacedo]

Hi All,

so as I mentioned on previous comment. I did open a ticket with SAP and they acknowledged the issue and will add the fix. here is their response: "We plan to implement a fix in the DIG component to address the inconsistency found in the DIG API response."

The workaround (works 90% of the time) is to after you press the "Stop" button, wait few minutes for the job be stopped in the background. Then press the "stop" button again. You will see an error message saying something like "Replication flow cannot be stopped...." Close the message, refresh the data monitor job. The status should be refreshed. 

hope this helps some of you.