Info Idoc received with status 8

[Former Member]

Hi Gurus,

I am trying to load the data from SAP ECC . I am getting the following error.

"Info Idoc received  with status 8" .

This is happening across the board , means that i am not able to make any load from ECC.

This is simple full load for 0Material_attr . It's in Dev . In ECC RSA3 i can see there is some

data . That means BW should pull the data . I checked whole SDN and google.

I already followed all the suggestions.

1) Activate & replicate

2) No errors in  SM50,SM21, WE20 , SM58.

Could any one help.

Thanks

Magge

[former_member210724]

Hi magge,

Check the data is coming to RSA 3 or not and also check whether any code is there at R3 level and also check selections at infopackage level.

In my project also for a particular load, it will give the same message "IDoc message with status 8" when the table doesn't contain data according to my selections.

regards,

anand.

[Former Member]

Hi Anand,

Thanks Anand.Yes the data is there when you pull from RSA3 and there are no selections and it's full load.

Could some one help .

Thanks

Magge

[ravi_chandra3]

Hi magge,

Plz refer the below link

http://scn.sap.com/thread/2039292

Thanx & Regards,

RaviChandra