i want to execute an unattended job on my remote desktop connection

[paul_schuette96]

Hello everyone,

i want to execute an unattened job on my remote desktop connection, i've created the unattended trigger. If I activate it directly from the control tower, nothing happens. 

I have saved the credentials in the agent and switched the mode to unattended more. 

After logging in again, the password is no longer displayed in the agent. Is this normal behavior?

Thank you and best regards 

Paul

[Sankara1]

Hello Paul,

Thank you for reaching out. Could you please share a screenshot of your Control Tower's Agent status? It would be helpful for further investigation.

[Former Member]

Hello @paul_schuette96 ,

I've tried to save the password in my agent (Version 3.22.45). After a restart, it didn't show the password either.

Is your agent visible and available in the control tower? The last time I had an issue like yours, the agent wouldn't start because the agent version required in my project was higher than the version of my installed agent.

Best regards,
Rafael