Event not reaching Event Mesh

[sascha_federau]

Hi,

I am currently trying to send equipment events (Create/Change) from an S4 OP to Event Mesh. I have used various blogs as a guide and everything seems to fit. The connection test works, the daemon is running, everything is set on the BTP side and everything is green in the Channel Monitor.

However, nothing arrives in the event mesh queue.

When I look at the event queue browser, I can also find all my events there (based on the changes in the equipment)

However, I have now noticed that nothing is arriving in the Event Monitor (only the test event i made with /IWXBE/R_PRODUCE_TEST_EVENT)

Do you have any idea, what could be wrong?

Many thanks and best regards,
Sascha

[Ryan-Crosby]

Did you create your outbound binding for the equipment object?

[Ryan-Crosby]

Did you configure the event linkage with the flag for "Enable Event Queue"?

[Ryan-Crosby]

The ones of interest are the 'BEH' linkages - if you set the flag then it runs in the background (not sure the trigger - daemon maybe), but if you leave the flag clear then it should be immediate send.

[sascha_federau · Accepted solution]

Hi Ryan,

yes, i've maintained all the topics for Equipment:

[sascha_federau]

Hi Ryan,

could solve the issue. The corresponding OData-Service was missing.

Again, thanks a lot for your help!!

[Ankitkumar_Singh]

Which Odata Service was missing. I am facing the same issue. Could you Please help here.

[sascha_federau]

I hear that the first time 🙂

Did a short research and found the transaction SWETYPV ("Type linkages").

There are some entries in the EQUI context, but the flags are not maintained:

I activated two of them (BEH sounds like BI):

But it's still not working. Do i have to created special ones for the Service Clouds?

Thanks for your support!!!