data is not pulling from ECC

[former_member207019]

Dear All,

When I have extracted using Full extraction mode, data got into BW system. Due to some time lapse, it got failed.

Then I have pulled using selection of few plants, but data is not pulling.

Source side, data is available. What needs to be done.

Regards,

Jo

[former_member189089]

Hi,

Please check the below following.

1.RSA1 - Source system connection check ,If not working as expected

2.RFC's from both source and target system

3.WE20 and WE21 entries in both source and target system for both instances

4.Check in WE21 is partner port is active(If not active ,activate it),Check all message types Inbound and Outbound,to see if parameters are correct.

5.Check SM58 for stuck tRFC(Execute LUW's)

6.Check BD87 for stuck iDocs(Process IDocs)

7.Reactivate Source system using RSA1

Try if anything works.

Thanks

[RamanKorrapati]

Hi,

is it full load or delta load?

While running info pack thru selections, have you checking info pack montior details?

is it still running or failed?

Check at source side job log at SM37 and SM58.

if its full load then delete psa loaded request and again reload it.

if previous load was failed then can you share error message.

Thanks

[former_member207019]

It is generic data source and it is full Load. First time, I am trying to pull it in BW system.

When I have checked monitor tab, it is saying No Idocs arrived from the source system.

When I have checked the data in source system for these selections, it is available and it is very limited data i.e. around 2000Records.

[RamanKorrapati]

Hi,

please check at SM58 and cross check about RFCs between ecc and bw system.

Generic data source based on?

Thanks

[former_member207019]

Generic Data Source is based on View. No Delta Concept applied. It is full extraction.

In SM58, it is showing nothing.

[RamanKorrapati]

other than this load, are you able to load data from ECC to BW?

ask basis team to check about IDOCs and RFC configurations.

check WE20 - whether partner profiles was active or not.

[former_member207019]

Yesterday Full Mode extraction got terminated the job at source side.

Now when I extract using selection based full mode extraction, it is not happening.