Configuring reciever port for outbound IDOC

[btekcan12]

Hello all,

Here I am facing with an issue about outbound IDOC's. Our customer has copied their P system to Q. After that some configurations were done for rfcs,idocs etc. But currently IDOCS are not working. 

I got a general error message when i checked we02 

''IDoc could not be processed without errors''

I have digged a little bit and find out the reciever port was not determined properly.

On Q, I got this ( please see the attached image) but normally it should be A00000X. I have already checked we20 and we21. everything looks same as P system.

Can someone help me about this issue? 

[jakob_steen-petersen]

Check BD84. And after that check LS S17EWM100 (asume it´s a testsystem?) you can find the port in detail section of Outbound parameters for SHPMNT

[btekcan12]

Hello,

thank you for your reply. but i could not find out how to configure the port with this path?

I am looking for a customization actually, to get proper port(A00000x) instead of QHO

[RaymondGiuseppi]

Did you read (and apply) SAP suggestion from online documentation

• Look for 'This wiki provides details on keeping ALE settings, for example the Distribution mode (BD64), ports in Idoc processing (WE21), and Partner Profiles WE20.'

[btekcan12]

hello,
thank you for your reply. I have checked the link that you have sent. I ve tried to execute first step '' model distribute on edit tab.
I got this error message. any advice?

Should i delete the pre-created entries before? I created them manually to add ''shpmnt'' message type on Q system. 
Before QHOCLNT300 there was only PHO which was copied from P.