Call WS RCVR_DETERMINATION.NO_RECEIVER_CASE_BE

[Former Member]

Hello,

We are facing probleme calling WS from ECC through PI.

Our scenario is synchrone : ECC -->PI->WS and the response to ECC .

An exception occurred which is explained in detail below.

The exception, which is assigned to class 'CX_AI_SYSTEM_FAULT', was not caught

and

therefore caused a runtime error.

The reason for the exception is:

Erreur (id=RCVR_DETERMINATION.NO_RECEIVER_CASE_BE)

I refresh the Cach, check the receveir determination, but still the same problem.

[former_member332004]

did you solve ?

[Former Member]

Any idea ??

[iaki_vila]

Hi Mou,

Try to create the receiver channel without the * on the sender party.

Regards.

[Former Member]

HI,

Thank you for your responce, actualy I have this error :

[iaki_vila]

Hi Mou,

The text is in french, in think the endpoint is generating this exception because you are not using a code page or the code page used is erroneous. Try to use TextCodepageConversionBean or XmlAnonymizerBean (page 5 http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/502991a2-45d9-2910-d99f-8aba5d79f...)

Regards.

[Former Member]

Thank you,

Where can I add this code page ? in the sender using the XI adapter ?

[iaki_vila]

Hi Mou,

I was thinking the message was arriving to the receiver side and my idea was to add in the SOAP receiver side. Are you using a sender abap proxy to do the communication or a RFC?

Regards.

[Former Member]

Hi,

My sender ( ECC)  use XI adapter, and the receveir HTTP adapter, as I mentiend in the screenshots above.

Any idea please ?

Cordialy

[apu_das2]

Hi mou,

This is due to the configuration issue in SLD.

Check the BS , SWCV you defined in SLD under which your SI lies . Check the Product assigned to the SWCV and Technical system assigned to BS.

Some days before we had also faced the same issue.

Thanks,
Apu

[justin_santhanam]

Hello Mou,

I hope you have correctly defined the Outbound(From ECC) an Inbound Interface(to WS) as Synchronous interfaces, correct?

Thank you,

Justin.

[Former Member]

Yes that exactly what I did.

[ravicarpenter]

Hi,

Is your scenario triggered by an ABAP proxy ? If so, are you able to see the message in the SXMB_MONI on the ECC side. From the MONI, check the sender and the interface name. Correspondigly in PI can you see the receiver determination for the same ?

[Former Member]

Hello,

you find in the attachment below , the entries in sxmb_moni in PI, and its content :

[iaki_vila]

Hi Mou,

Have you checked your scenario from ID test tool?

Check your configured receivers in the Receiver determination, the must fit with your receiver agreement receiver side and if you have a typo error.

If you can, you can share a screenshoot of the objects.

Regards,

[Former Member]

Hi, You can find the receiver ( WS), the receiver determinatino and the sender ECC :

[former_member186851]

is it a sync or async scenario?

[Former Member]

Hello,

It s a sync scenario.

[former_member186851]

Can you refer the below link,might be helpful

[Former Member]

Hello,

I copied the Receiver with an other name and modify the receiver agr but stil the same prob.