cancel
Showing results for 
Search instead for 
Did you mean: 

Attribute 0CURRENCY for InfoObject 0CO_AREA and value could not be read

vikram_bagade5
Explorer
0 Kudos
202

Hello,

While running the retraction from BPS0, i am facing the below error.

=======================

Attribute 0CURRENCY for InfoObject 0CO_AREA and value could not be read

Message no. UPB_CI024

Diagnosis

Master data attribute 0CURRENCY should be read for InfoObject 0CO_AREA

for value . However, this failed.

System Response

Processing is terminated.

Procedure

Load the master data for value of InfoObject 0CO_AREA. Make sure that

the master data are active and the attribute 0CURRENCY on InfoObject

0CO_AREA exists.

====================

I have loaded the master data for the object 0co_area and the attribute 0currency is holding the appropriate value required, however the issue still persists.

In the infoobject maintenance screen rsd1, in the masterdata/textx tab, i can see only the tables generated for View of MstrDtaTbls - /BI0/MCO_AREA and Master data tab /BI0/PCO_AREA. however the SID table attr (table) is blank. I have run RSRV, RSDMD_CHECKPRG_ALL etc...however no results.

Has anybody come across such issue. Please help.

Thanks and Regards,

Vikram

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi,

Do "Attribute Change Run" for 0CURRENCY and do "MasterData Activation" step for 0CO_AREA.

Rgds,

Ram

Anand71
Active Contributor
0 Kudos

Hello,

Please check the following notes :

Note Number : 326747, 668854

Thanks.

With regards,

Anand Kumar

Former Member
0 Kudos

Hi,

Check for the CR relationship activation at planning area,secondly check in upbr_rule.

Regards,

Indu