Unable to complete the Delivery readiness in EWM in Advanced Shipping & receiving scenario.

[former_member808935]

I am running Advanced Shipping & receiving scenario. After completing the picking, I am trying to set the Delivery readiness to '9' (tried both manual and using report) but getting an error which says "1 deliveries cannot be set to ready for shipping: incomplete picking". However, I see that picking status is completed. Can you please help.

Thank you

Stalin

[former_member802086]

Hi Stalin,

Please check if you have activate DSH (Shipping readiness) in status profile. check status profile in document type setting.

Ex - /SCDL/OUT_PRD_STANDARD

For Outbound delivery type set below status type in status profile for doc type and item type

DBT (Block Transportation Planning) - Inactive

DTD (Transportation Planning) - Active

DTU (Assign Transportation Unit) - Inactive

DSH (Shipping readiness) - Active

[former_member808935]

Hello Shriram,

All the mentioned settings are already done. And without these settings, the delivery will get get stuck in SMQ2(that happened initially when I was doing the set up). mail.aslam.ansari also mentioned the same in the below answer.

[reinerinkrob]

You should probably check this note: https://launchpad.support.sap.com/#/notes/3225607

The job is not always working when scheduled in background.

[former_member808935]

Hello Team,

One update on the issue. I can successfully complete the Shipping Readiness manually using monitor. However, issue persists while doing it through the report /SCWM/R_SET_DSH_STAT_AUTOMATIC. I already maintained the "Set Shipping Readiness for Deliveries Automatically" in the configuration as shown below. Am I missing any other prerequisites settings to run this report?

[former_member788724]

Please check if you have activate DSH (Shipping readiness) in status profile. check status profile in document type setting.

Hello,

Just a lighter side comment.

If DSH is not active then in fact delivery won't be distributed to EWM. It will hang in the SMQ1/Q2.

Can you please share with us the EWM Outbound delivery order header status where we can see the picking progress?

Regards

ASLAM

[former_member808935]

Hi Aslam,

You are right, DSH is already active. Please find the screenshots below.

Delivery Header:

Status Tab:

asr-picking-completed-2.png