Transfer using 311 to EWM

[Former Member]

Hi Gurus,

I have a problem here regarding a stock transfer between two storage locations using transaction VLMOVE using moviment type 311. I'm moving the stock from a MM-IM to a EWM storage location.

Storage Location A is MM-IM

Storage Location B is EWM

Material is batch managed

Tcode VLMOVE creates the Inbound delivery without specifing the batch number and distribut normally to EWM.

When I perform the GR on EWM side the queue gets stuck in SMQ2 on ERP side asking for the batch with a error message M7018, but it was informed in EWM and the queue have the batch information.

Does anyone have a solution for this?

Best regards.

[pavan_godavari]

Hi Jussier,

Is the issue already resolved? If no, can you check if below config exists in your system?

SPRO - EWM - Interfaces - ERP Integration - General Settings - Set Control Parameters for ERP Version Control - For your business system, check under "BATCH Control" section, which option is selected.

capture.png

Best Regards,

Pavan

[Former Member]

Hi Pavan,

Thank you for your answer.

Yes, the batch already exists in ECC.

I'm using VLMOVE because MIGO requires informing the Batch in advance before creating de Inb. Delivery, but we do not know the batch until the warehouse personal reads the batch number in EWM and post back the information to ECC.

[pavan_godavari]

Is the batch already in ECC? If no, can you create it manually and later try to reprocess the queue?

Also, what is the reason to use VLMOVE and why not do 311 using MIGO?

Best Regards,

Pavan